Installation of ZG-HF80 High Frequency Induction Heating Hardening Machine

1. Cooling water connection of ZG-HF80 High Frequency Induction Heating Hardening Machine

Water pipes would be connected the running water or customers self-equipped water pump (recommended: water pressure 0.05~0.2Mpa or water flowing amount 2~5L per minute) with ‘Water input’(one on the back of main power control cabinet and two on the back of capacitor box) and Water Output (one on the back of main power control cabinet and two on the back of capacitor box) to running away or a small pool or a big pail for recycling use.

Please pay attention to the following points:

a.Stable water supply, better to use a water pump.

b.Keep water clean and no corrosiveness;

c.Keep water temperature below 50℃;

d.Check cooling water run fluently.

2. Input power connection

Connecting power supply cables to theInput Power Wires Pillars of back-plate using 6 cubic centimeter soft copper wires.

3. Ground wire connection

Connecting grounding wire to the Grounding Wire Input of back-plate using 4 cubic centimeter soft copper wires.

4. Induction Coil installation

Tighten the two screw nuts which on the ends of induction ring to the brass screws on capacitor box front. Please not to use water-proof thread sealing tape here, because the induction ring has low voltage and current in case electricity leak away.

5.Pedal switch connection

Plunge the pedal switch into the plug socket on the back of main power control cabinet.